Low pressure loss ! Low cost ! Light !
|
Highly efficient |
High-blow nozzle SUS
|
Compressor and high pressure blower are not necessary !! |
|
|
||||||
|
Low pressure loss ! Low cost ! Light ! |
||||||
|
|
|
High-blow nozzle SUS |
||||
|
||||||
|
|
|
|
|
|
|
|
|||||||||||||||||
|
|
|
|
|
|
|
|
Simple inside rectification structure |
Slit width adjustment type |
||||
|
|
|
||||
|
Material is adopted stainless steel (SUS304 Surface finish 2B). |
Hexagon stick spanner for the adjustment of the slit width is equipped. |
||||
|
|
|
|
Specification
|
||||
| MODEL | 65SUS | 75SUS | 100SUS | 125SUS |
| Bore of inlet | φ65 | φ75 | φ100 | φ125 |
| Adjustment range of slit width | 0.5 - 2.0mm | 0.5 - 2.0mm | 0.5 - 3.0mm | 0.5 - 4.0mm |
| Manufatureable slit length |
Slit length 300mm -
1900mm at slit width 0.5mm - 1.0mm Slit length 300mm - 1000mm at slit width 1.1mm - 2.0mm |
Slit length 300mm -
1900mm at slit width 0.5mm - 1.0mm Slit length 300mm - 1500mm at slit width 1.1mm - 2.0mm |
500mm - 1900mm |
500mm - 1900mm |
| Efficient use air-speed |
25 - 120m/s at slit
width 1.0mm 25 - 100m/s at slit width 2.0mm |
50 - 150m/s at slit
width 1.0mm 25 - 80m/s at slit width 2.0mm |
50 - 150m/s at slit
width 1.0mm 25 - 80m/s at slit width 2.0mm 25 - 50m/s at slit width 3.0mm |
25 - 150m/s at slit
width 1.0mm 25 - 100m/s at slit width 2.0mm 50 - 100m/s at slit width 3.0mm 50 - 75m/s at slit width 4.0mm |
| Heatproof temp. | Less than 350ﾟC | |||
| Resisting pressure | Less than 49kPa | |||
| Accuracy rating | Disorder of the air-speed of the right and left is less than plus minus 5% (Except the both ends department 25mm of slit) | |||
| Open price | JPY 81,000 - JPY133,000 | JPY 96,000 - JPY155,000 | JPY118,000 - JPY184,000 | JPY177,000 - JPY236,000 |
Product of this
mark 
can be forwarded
by EMS (International Postal Service) in the case of direct order.
To
Direct Estimate
about details.
Specification are changed without that tells to improve performance.
| Catalog of this product is ... | Get the catalog just now |
Operation manual of |
Selection of the high-blow |
|||||||||||
|
|
|
|
 |
|
||||||||||
